Installation guide

19-3
Messages 200 – 299
Explanation: The access server is receiving messages that violate the LAT protocol.
Local -208- Connection to service-name terminated
Service node retransmission limit exceeded
Explanation: The connection request failed or the existing connection was terminated
because the retransmit limit on the circuit has been reached. When the retransmit limit is
reached, the circuit between the access server and the service node is terminated.
Action: Verify the LAT service configuration (Chapter 2).
Local -210- Connection not established, queued access timeout
Explanation: A connection request failed from a port with QUEUING enabled to a
service. This could happen if queuing is disabled for the service or if the queue limit has
been reached.
Action: Use the SHOW SERVICE CHARACTERISTICS command to determine if
queuing is disabled. For more information on configuring and managing the LAT
connection queue, refer to the Network Access Software Management Guide.
Local -211- Connection to service-name not established
Protocol error: illegal circuit
or
Local -212- Connection to service-name not established
Protocol error: credits
or
Local -213- Connection to service-name not established
Protocol error: start/run
or
Local -214- Connection to service-name not established
Protocol error: maximum < current
Step Action
1 Try to reconnect to the service.
2 If the connection fails, reinitialize the access server to downline load the software.
3 Verify that the access server is running the latest software.
4 Try to reconnect to the service.
5 If the error messages reappear, you might have a software problem.