Manualshelf

Installation guide

ManualsBrandsCabletron Systems ManualsComputer equipmentAccess Server 316
201202203204205206207208209210
Messages 200 – 299
19-2
Local -203- Connection to service-name not established
Service node retransmission limit exceeded
Explanation: The connection request failed or the existing connection was terminated
because the retransmit limit on the circuit has been reached. When the retransmit limit is
reached, the circuit between the access server and the service node is terminated.
Action: Verify the LAT service configuration (Chapter 2).
Local-204- Autoconnect retry limit exceeded.
Explanation: Autoconnect failed to establish a connection within the maximum number
of allotted retries. This service may be incorrectly spelled or may not be available.
Action: Verify the service name. Try again later. Contact your system administrator.
Local -205- Connection to service-name not established.
No response to solicit information request.
Explanation: The access server’s database did not contain the service and node
information required to establish a connection to the specified service. As a result, the
access server attempted to solicit the information from other nodes on the network and did
not receive a response.
Local -206- Connection to service-name terminated
No response within timeout period
Explanation: The connection request failed or the existing connection was terminated
because the retransmit limit on the circuit has been reached. When the retransmit limit is
reached, the circuit between the access server and the service node is terminated.
Action: Verify the LAT service configuration (Chapter 2).
Local -207- Connection to service-name terminated
Communication protocol error
Step Action
1 Verify that the service name was entered correctly.
2 If you specified a node as part of the connection request, verify that you entered the
name correctly and that the node offers the service.
3 Verify that the port’s group codes allow access to the service.
4 Enable autoconnect and retry the request. Be sure to allow several minutes for the
connection to be established.
5 Increase the access server’s node limit.