Installation guide

Software Installation Problems
1-2
Access Server Software Does Not Load Properly
Verify the Network Access Server Hardware
Check the LEDs on the hardware. For information on the LED codes and site preparation
information, refer to your access server hardware documentation.
Verify the Image Name and Flash RAM
The load image name should reflect your access server type and appropriate version
number.
Your access server may be equipped with Flash RAM. Flash RAM maintains an image of
your current software on your access server.
To display the image name and determine if your system is equipped with Flash RAM,
enter the following command:
Local> SHOW MEMORY CONFIGURATION
Dynamic RAM: 4M bytes
Non-Volatile RAM: 128K bytes
FlashRAM:
Installed: Yes
Total size: 2 Mbytes
Boot block: Valid
Load image:
Name: WWENG2
Size: 1756988 bytes
Version: Network Access SW Vn.n BLnn-nn
DECserver 700 DECserver 90M DECserver 900
Software WWENG2 MNENG2 WWENG2
Image(s) MNENG3
MNENG3 is a non-compressed image for DS90M platforms. Use of MNENG3
requires that the DS90M is configured with 2 MB Flash RAM.
NOTE