Installation guide

17-7
Directed TFTP Problems
Directed TFTP Error and Status Messages
Local -903- [DTFTP] Loading from host nnn.nnn.nnn.nnn [ETHERNET]
Explanation: Indicates that a particular host is now loading from DTFTP. The
BOOTP form of this message remains the same as before, for example:
Local -903- [IP] Loading from host nnn.nnn.nnn.nnn [ETHERNET]
Action: None.
Local -912- [IP] Load failure, timeout.
Explanation: The access server did not receive a completed image load within the allotted
timeout period. If Directed TFTP is being used, it might be that the IP address of the TFTP
server is incorrect, the host may not be running the TFTP server process, or the network
connectivity to the TFTP server may be faulty.
Action: Follow these steps to solve the load failure timeout problem:
1. Verify that the TFTP server is reachable on the network. Try a PING to the host.
2. Verify that the TFTP server is running the TFTP process. Consult your operating
system documentation.
3. Verify that the access server has a local IP address.
4. Verify that the access server has a default gateway IP address if it needs one.
Local -915- [DTFTP] Access Server local IP address not specified.
Explanation: The access server ROM firmware is attempting to perform a Directed TFTP
image load. The access server does not a have a source (or local) IP address, which it must
have to initiate TFTP.
Action: Invoke the access server ROM firmware Mini-Monitor by entering Ctrl/B twice,
at the access server physical console. At the >>> prompt, temporarily configure an IP
address for the access server. For example:
>>> s ip=192.10.444.3
Enter the boot command to resume. For example:
>>> b eth:mneng2