Installation guide

16-9
Remote Login Problems
Rlogin Client Characters Do Not Display on Terminal
Solution
If characters do not display during a Rlogin session, enter the following command.
Substitute the number of the port for 1.
Local> SHOW PORT 1 RLOGIN CHARACTERISTICS
Rlogin Characteristics Port 1:
Terminal type: Unknown
Escape character: ~
Suspend input to server: ^y
Suspend server I/O: ^z
Procedure
Do the following:
More Information
If the procedure in this section did not solve the problem, the Rlogin client may have hung.
Alternatively, it is possible that the Rlogin characteristics have changed on the port since
the session began. If you do not know the previous values, log out the port.
Step Action
1 Use Ctrl/] to get a Local> prompt.
2 Use the SHOW PORT 1 RLOGIN CHARACTERISTICS command to determine the
suspend input and suspend I/O characters.
3 Resume the session.
4 Enter the suspend input character, then try typing again. If unsuccessful, enter the
suspend I/O character, then try typing again.