Installation guide

11-13
Printer Configuration Problems
On the access server, enter the following command:
Local> SHOW SERVER
Access Server Vn.0 for DSnnn-nn BLnn ROM Vn.n-n Uptime: 9
10:57:42
Address: 08-00-2B-01-23-45 Name: GEMINI
Number: 0
Identification: UNAUTHORIZED ACCESS PROHIBITED
Circuit Timer: 80 Password Limit: 3
Console Port: 1 Prompt: Local>
Inactivity Timer: 30 Queue Limit: 100
Keepalive Timer: 20 Retransmit Limit: 8
Multicast Timer: 30 Session Limit: 64
Node Limit: 200 Software: WWENG2
TFTP Host: None
Service Groups: 1,5
Enabled Characteristics:
Announcements, Broadcast, Dump, Lock
If the access server port is set up as a service, the access server Service Groups must have
at least one group code in common with the service node groups. In this case, the access
server Service Groups are 1 and 5. These Service Groups match those of the service node.
For more information on specifying group codes for a LAT service, refer to the Network
Access Software Management Guide.
Determine If Service Is Offered
If printing to a service, determine if the requested printing service is offered. Enter the
following command on your access server. Substitute the number of the port that offers the
service for 1:
LOCAL> SHOW PORT 1 SUMMARY
Port Access Status Services Offered
1 Remote Idle Printer_service
If port 1 does not offer the requested service, refer to the Network Access Software
Management Guide for more information on configuring a printer as a LAT service.