Installation guide

Printer Configuration Problems
11-10
Having the queue in a paused state usually means a hard error. Perform the following to
determine why:
Step Action
1 Verify to see if the wrong queue processor is being used. Enter the following
command. Substitute the name of the queue for EARTH$LASER:
$ SHOW QUE/FULL EARTH$LASER
Terminal queue EARTH$LASER, paused,on
EARTH::LTA8000:,mounted form DEFAULT
/BASE_PRIORITY=4 /DEFAULT=(FEED,FORM=DEFAULT) Lowercase
/OWNER=[1,4] /PROCESSOR=LATSYM
/PROTECTION=(S:E,O:D,G:R,W:W)
/RETAIN=ERROR
If the processor name is not LATSYM, stop the queue and reinitialize it using
PROCESSOR=LATSYM.
Note
: Check that the LATSYM processor is used on all OpenVMS nodes that offer
LAT print queues.
2 Verify to see if the wrong output device is being used. Enter the following command.
Substitute the device number for 8000:
$ SHOW DEVICE LTA8000:/FULL
Verify that the output device type assigned to the LTA: device matches that of the
printer.