Installation guide

11-3
Printer Configuration Problems
Verify the Port Configuration
Procedure
• Verify that the printer port is configured correctly. Enter the following command,
substituting the port number for 2:
Local> SHOW PORT 2
Port 2: PORT_2 Server: MMS1
Character Size: 8 Input Speed: 9600
Flow Control: XON Output Speed: 9600
Parity: None Signal Control: Disabled
Stop Bits: Dynamic Signal Select: CTS-DSR-RTS-DTR
Access: Remote Local Switch: None
Backwards Switch: None Name: PORT_2
Break: Disabled Session Limit: 4
Forwards Switch: None Type: Hard
Default Protocol: LAT Default Menu: None
Autolink Timer One:10 Two:10 Dialer Script None
Preferred Service: None
Authorized Groups: 0
(Current) Groups: 0
Enabled Characteristics:
Inactivity Logout, Input Flow Control, Output Flow Control,
Signal Check
• Verify that the Access characteristic is set to Remote or Dynamic and Break is
Disabled. Note that the SHOW PORT display will vary depending on the hardware you
are using. For more information on configuring a printer, refer to the Network Access
Software Management Guide.
• Verify that you are using the correct modem signals and cables. For information on
configuring modem signals for your access server hardware, refer to the Network
Access Software Management Guide.
• Verify whether the printer requires XON Flow Control. For information on configuring
printer settings for your access server hardware, refer to the Network Access Software
Management Guide.