Installation guide

10-7
Terminal and Personal Computer Problems
Terminal Screen Scrolling When MONITOR Command Is Used
If your terminal screen scrolls when you use the MONITOR command, enter the
following command. Substitute the number of the port where the screen is scrolling for 1:
Local> SHOW PORT 1
Port 1: Michael Server: GEMINI
Character Size: 8 Input Speed: 9600
Flow Control: XON Output Speed: 9600
Parity: None Signal Control: Disabled
Stop Bits: Dynamic
Access: Local Local Switch: ^^
Backwards Switch: None Name: PORT_1
Break: Local Session Limit: 8
Forwards Switch: ‘ Type: Ansi
Default Protocol: LAT Default Menu: None
Autolink Timer One:10 Two:10 Dialer Script: None
Preferred Service: GALAXY
Authorized Groups: 60, 70, 80
(Current) Groups: 60, 70, 80
Enabled Characteristics:
Autobaud, Autoconnect, Autoprompt, Broadcast, Input Flow
Control, Loss Notification, Message Codes, Multisessions,
Output Flow Control, Verification
Verify the Type characteristic is set to ANSI. The Type characteristic controls device-
specific functions. For more information on the MONITOR command, refer to the
Network Access Software Commands Reference Guide.