Installation guide

Terminal and Personal Computer Problems
10-6
Command Line Recall Not Working
If command line recall is not working, enter the following command. Substitute the
number of the port where command line recall is not working for 1:
Local> SHOW PORT 1
Port 1: Michael Server: GEMINI
Character Size: 8 Input Speed: 9600
Flow Control: XON Output Speed: 9600
Parity: None Signal Control: Disabled
Stop Bits: Dynamic Signal Select: CTS-DSR-RTS-DTR
Access: Local Local Switch: ^^
Backwards Switch: None Name: PORT_1
Break: Local Session Limit: 8
Forwards Switch: ‘ Type: Ansi
Default Protocol: LAT Default Menu: None
Autolink Timer One:10 Two:10 Dialer Script: None
Preferred Service: GALAXY
Authorized Groups: 60, 70, 80
(Current) Groups: 60, 70, 80
Enabled Characteristics:
Autobaud, Autoconnect, Autoprompt, Broadcast, Input Flow
Control, Loss Notification, Message Codes, Multisessions,
Output Flow Control, Verification
Verify the Type characteristic is set to ANSI. The Type characteristic controls device-
specific functions. For more information on command line recall, refer to the Network
Access Software Management Guide.