Installation guide

8-5
User Authentication Configuration Problems
Verify That Authentication Is Enabled
Procedure
To use the security user authentication system, you must enable authentication for each
port. To display the user authentication settings for an interactive user port, use the
following command. Substitute your port number for port 1:
Local> SHOW PORT 1
Port 1: Test Server: GEMINI
Character Size: 8 Input Speed: 9600
Flow Control: XON Output Speed: 9600
Parity: None Signal Control: Disabled
Stop Bits: Dynamic Signal Select: CTS-DSR-RTS-DTR
Access: Local Local Switch: ^^
Backwards Switch: None Name: PORT_1
Break: Local Session Limit: 8
Forwards Switch: None Type: Ansi
Default Protocol: LAT Default Menu: None
Autolink Timer One:10 Two:10 Dialer Script: None
Preferred Service: GALAXY
Authorized Groups: 60, 70, 80
(Current) Groups: 60, 70, 80
Enabled Characteristics:
Authentication, Autoconnect, Autoprompt, Broadcast,
Failover, Input Flow Control, Lock, Loss Notification,
Message Codes, Output Flow Control, Lock Notification,
Verification
If authentication is not enabled, enter the following command. Substitute your port
number for port 2:
Local> DEFINE PORT 2 AUTHENTICATION ENABLE