Specifications

Corrected & Known Anomalies
SPECTRUM Software Release Notice Page 165
message appears instead, or the Performance view shows red-boxed
attributes.
Solution: This is a firmware problem. Upgrade to the SmartSwitch 6500
with 2.4 firmware, which provides the MIB-II performance parameters. Set
Primary Application to MIB-II; launch the Performance view from the
device model.
Problem 7: In the ATM Switch Application Virtual Path Links table view
for the SmartSwitch 2500/ZX_250SwitchApp, the Admin Status field
shows a “0” value. Double-clicking any table entry displays the ATM
Switch Application VPL table view, showing the Admin Status field with a
“???” value. In both views, the device should return a “1” value for Up, or
“2” for Down.
Solution: This is a firmware problem.
Problem 8: The ZX250SwitchApp for the SS6500_CSM is displaying some
red-boxed fields in the Switch Memory/Heap Stats view firmware 2.04(9).
Solution: This is a firmware related problem.
Problem 9: The ZX_250 Switch application’s Configuration view shows
red-boxed fields.
Solution: This is a firmware related problem.
Problem 10: The SmartSwitch 6500’s Zeitnet Systems Extensions view
shows red-boxed fields.
Solution: This is a firmware problem for the SmartSwitch 6500; the field
attributes are not supported.
Problem 11: You will be unable to update the Admin Status of an active
port of an 9A100 device in the Application view > Large Icon > Device
Interface view > IF Configuration view. An error message will be displayed.
Solution: This is a firmware related problem.
Problem 12: The 6A000 model may display “Failure” or no values in some
of the fields in the Gen_IF_Port Performance view.