Specifications

Corrected & Known Anomalies
SPECTRUM Software Release Notice Page 134
because VLAN information is not supported for Extreme Summit switches
running a version of ExtremeWare that is earlier than 6.0.
Problem 3: SPECTRUM AutoDiscovery will connect an Alpine 3808
running firmware 6.1.7 and a Summit 48i running 6.1.8 using EDP but
will not connect them to any non-Extreme devices.
Solution: For these devices running these particular firmware versions to
get connected to non-Extreme devices, you must Telnet to each Extreme
device and enable the dot1d MIBs. This is not necessary if you upgrade the
firmware to Extremeware 6.2 because it uses a proprietary MIB for
connectivity.