Specifications

Corrected & Current Anomalies
SPECTRUM Software Release Notes Page 178
ILMI parameters must be set. (Use local management to do this.) The
following summarizes the creation procedure using a Zeitnet device. The
procedure will be similar for the other devices.
1 In a Virtual Channel Link view, set the link information (IF Index, VPI,
and VCI). For example, 20101.0.160.
2 Save the link by pressing <Return> and then clicking the Create Link
button. The VCL Row Status view displays.
3 Assign traffic parameters for transmit and receive and then click
<Return> to save.
4 Click the Validate Row button and then wait to see that the row
status changes from Not Ready to Active.
5 Return to the Virtual Channel Link Table view to validate that the link
was defined with the assigned traffic parameters.
6 That completes the link definition for the first port to be cross
connected. Now repeat the above steps to complete the link definition
for the other port.
7 When the links are defined correctly for both ports, go to the Virtual
Channel Cross Connect view and follow the instructions in this view
to cross connect the two ports for which you defined links. Cross
connecting establishes the PVC.
8 You should return to the Virtual Channel Link view to ensure that the
PVC has been set properly.
Problem 8: When the Community Name is changed in the Model
Information view of a SmartSwitch 9000 device, the interfaces in the
Chassis Device view do not display a status change but remain in whatever
state they were in when contact was lost with the device.
Solution: The interface number field turns gray to alert you that contact
was lost; however, knowing the previous state of the interface is considered
to be useful information.
Problem 9: The graph in the ATM Performance view seems to display