Specifications

Corrected & Current Anomalies
SPECTRUM Software Release Notes Page 137
Cisco Catalyst
Known Anomalies:
Problem 1: The HubCat5000 and HubCat5500 Interface Translation table
shows only Interface Index 1.
Solution: This is a firmware problem; the management module functions
as designed.
Problem 2: Modeling the HubCat5000, opening the Interface Device or
Device Topology views, and exiting after the ports configure, causes
multiple lines of the following message to appear:
CsDIEnumText: No match for Enumerated Value 268836429
Solution: This is a firmware problem; the management module functions
as designed. The device is sending incorrect interface information to
SPECTRUM.
Problem 3: For SwCat1200 models, clicking the CATStackApp’s
Configuration view Clear MAC or Clear Ports button causes a
SpectroGRAPH error message to display.
Solution: Use the read/write Community Name when modeling the
device. Then, each time you click either button, it clears and sets all MAC
and port counter attribute values to “0.”
SPECTRUM
Part Name
Device Firmware
MM
Version
SM-CAT1000 SwCat 1200 (Catalyst
Workgroup Switch)
4.1, 4.21 6.0 Rev 0
6.0.2
SM-CAT1001 HubCat 1400 (Catalyst
Workgroup Concentrator)
1.5 6.0 Rev 0
SM-CAT1002 HubCat 5xxx (Catalyst 5xxx) 2.1 6.0 Rev 0