Specifications

Management Module Anomalies
Management Module SRN 6.0 Rev 0 Page 62
SynOptics 5000 Hubs
Known Anomalies:
Problem 1: SynOptics only counts Good Frames when monitoring
Ethernet traffic. As the number of frames with errors goes up, the number
of Good Frames goes down, and this directly affects the Load value in the
Port, Segment, Cluster, and Attachment Performance views.
Solution: This is an agent problem. Users must evaluate the %Errors in
the Performance views and know that when the %Errors goes up, the Load
displayed does not reflect the actual load on the Ethernet segment.
Problem 2: In the Configuration view for the HubSyn5xxx model, Chassis
Contact and Chassis Location MIB objects are read-write on the device.
However, the device cannot be set with SNMP.
Solution: The objects can be set using local management and the values
will appear in the view. This problem will be addressed in a future release.
Problem 3: The SM-SYN1003 management module will not support the
5005 chassis.
Solution: This problem will be addressed in a future release.
SPECTRUM
Part Name
Device
Firmware
Version
MM
Version
SM-SYN1003 53xx Enet
55xx TR
59xx FDDI
1.5.1
1.5.1
2.2.6
6.0 Rev 0
SM-SYN1007 SynOptics
D5xxx
1.5.0 6.0 Rev 0