Specifications

Management Module Anomalies
Management Module SRN 6.0 Rev 0 Page 20
Problem 3: The CiscoPingApp currently supports only the IP and DECnet
protocols. The Ping Request Entry Table cannot display multiple protocol
address formats using a single table icon. For that reason, non-IP
protocols may display their respective addresses incorrectly in the table
view but the device receives the address as entered in the “Add Request”
window. .
Solution: Additional protocols will be supported in a future release of the
management module.
Problem 4: Clicking the Ciscoview menu choice, or the CiscoView button
in the Cisco Router MM, does not work.
Solution: For the Ciscoview functionality, the user must first install the
Ciscoview product. Additionally, the path to the executable must be
located in the user path. If these two conditions are not met, the Ciscoview
cannot be accessed.
Problem 5: When the Cisco router is modeled with a Rtr_Cisco model
type, some application models do not appear.
Solution: This problem occurs with firmware version 8.1 and earlier. The
Cisco management module now supports 10.0; with this firmware, the
application models should appear.
Problem 6: Some modeled Cisco devices allow you to enter any string
under Community Name, or leave this field blank. The model remains
green unless you remove the entered string, then the model displays an
orange alarm state.
Solution: The Cisco devices respond to all SNMP requests without
checking the community name.