Specifications

SetUp
Statistical Reports
Reports Standard RMON
F-2 Management Module Guide
SetUp
Monitor Point
Only a Probe model which has been copied into the corresponding Network
model as a Monitor Point can be used to run RMON Reports for that
network segment. It is not necessary that the Probe model be selected as the
current Monitor Point, only that it has been copied in as a candidate. For
information on how to make a Probe model a Monitor Point, please refer to
Section 2.4, Configuring RMON as a Network Monitor Point.
SpectroWATCH Logging
Once a Probe model is a Monitor Point, it is necessary to select which RMON
data you want to make available for reports. This is accomplished with
SpectroWATCH by enabling the logging option for the Watches you select .
See the following section describing the Cabletron supplied report generation
(rib) files for a list of the RMON data available through these reports. If you
wish to report on this data, it is necessary to select the logging option for each
first. Note that making any other data logged will not be available until a rib
file has been created which includes it.
For information on logging and SpectroWATCH, refer to the SpectroWATCH
Users’s Guide.
Statistical Reports
Report generation files are in the directory pointed to by the <CsRibpath>,
which is designated in either the .Xdefaults or app-defaults/spectrum files.
For more information on reports refer to the SPECTRUM Report Generator’s
Guide.