Installation guide

9
MMAC-Plus Installation Guide
Attaching the Electrostatic Discharge (ESD) Wrist Strap
The ESD Wrist Strap must be attached before handling the Environmental
Module or MMAC-Plus Interface Modules. In addition, observe all precautions
when handling these modules to prevent damage from ESD.
Attach the ESD Wrist Strap by following the steps below:
1. Attach one end of the ESD Wrist Strap to your wrist.
2. Plug the other end into the ESD Wrist Strap grounding receptacle in the front
lower right corner of the MMAC-Plus chassis, as shown in Figure 4.
Figure 4. Attaching the ESD Wrist Strap
ESD Grounding Receptacle
1125_01