Installation guide

5
MMAC-Plus Installation Guide
Installation
Required Tools
The following tools are required to install the 9C114 and 9C714 chassis:
• Phillips Screwdriver
• Flathead Screwdriver
• Electrostatic Discharge (ESD) Wrist Strap (provided with the chassis)
Unpacking the MMAC-Plus Chassis
Unpack the chassis by following the steps below:
1. Remove the unit from the shipping box.
2. Remove the protective plastic bag.
3. Remove the accessory package.
4. Remove the Electrostatic Discharge (ESD) Wrist Strap package.
Installation Order
Once a suitable site has been chosen, the MMAC-Plus may be installed. The unit
may be free standing or rack mounted.
It is recommended that the MMAC-Plus installation proceed in this order:
1. Mount the chassis to the rack or other secure location.
2. Install the power supply(ies).
3. Attach the Electrostatic Discharge (ESD) Wrist Strap.
4. Install the Environmental Module.
5. Install the Interface Modules.
6. If necessary, install the INB Terminator Modules.