Installation guide

A-3
Removing Security Bars
Figure A-2. Security Bar Installation
Removing Security Bars
The security bars should remain in place while the SmartSwitch 9000-6 Slot
chassis is operating.
Remove the security bars by loosening the two screws that hold each bar in place.
Slide the security bars out from behind the interface module plastic tabs. Be sure
to remove both security bars before attempting to remove any interface modules
from the chassis. Set the security bars aside for re-installation.
Security Bar
Interface Module
Plastic Tabs
MM AC -P lus 6
Chassis
Tighten with
screwdriver