User`s guide

9030971 E17 Exporting Data
4-7
Checking Export Output
Special Scheduler Requirements for NT
Removing Scheduled Export Commands
The Scheduler enables you to remove an entry from the Scheduled Entries
list before or after you have saved it to the scheduled queue.
To remove all entries you have added to the list but not saved to the scheduled
queue:
Click the Reset button.
To remove a single entry you have added to the list but not saved to the
scheduled queue:
Highlight the entry and click the Remove button.
To remove a single entry you have saved to the scheduled queue:
Click the Remove button and then click the Save button. If you exit
without saving, the entry will not be removed.
Special Scheduler Requirements for NT
This section discusses NT Schedule Service requirements:
• The NT Schedule Service must be running in order for the Scheduler to
function.
Make sure the Startup Type of the Schedule Service is set to “Automatic”
so that the Schedule Service is started automatically whenever the
computer is restarted.
• The Schedule Service must also log on with the proper User Account.
Be sure to specify that the Schedule Service logs on as a member of either
the Administrator’s group or the Backup Operator’s group. (Do not specify
the System Account—it cannot access the network.)
Then make sure the user or user group assigned to the Schedule Service is
also defined as a SPECTRUM user in SpectroGRAPH.
If you find that the Scheduler is not performing exports as scheduled, check
the NT Schedule Service Startup parameters. It is important to note that
when the Schedule Service parameters are incorrect, you can schedule
exports. The Scheduler, however, will not be able to perform the export.
Checking Export Output
This section describes output that Data Export writes to the output directory
for ASCII, SQL, and SAS data. You can examine an the contents of an export
output directory to determine if data was successfully extracted from
SPECTRUM databases.