Specifications

Port Level Security Configuration Screen
Local Management Supplement 2-7
Action On Intruder (Toggle)
Used to select the actions taken for the selected security state. There are
two fields to select the actions. Both toggle to activate or deactivate the
action.
• DisablePort/NoDisable – DisablePort causes the switch to turn off the
port that had a security violation. With NoDisable set, the port is not
turned off.
• SendTrap/NoTrap – SendTrap causes the switch to send an SNMP trap
when a port detects a security violation. With NoTrap set, no SNMP
trap is sent.
Address (Modifiable)
Used to enter the source MAC address for the LockedOnAddr security
state setting. Once a secure address is defined on a port, only those frames
received with that same source address are allowed on that port. Any other
frame detected with a different address is considered as an intruder,
causing the actions selected in the Action On Intruder field to be executed.
When the security state setting is NonSecure, the field displays the source
address of the last frame.
INTERFACE # (Selectable)
Used to select the front panel interface connector (ENET 1 to ENET 4) to
which the port security settings will be applied.
2.3.1 Setting the Port Level Security
To set the security for each repeater port on a connector, proceed as
follows:
1. Use the arrow keys to highlight the INTERFACE # field.
2. Use the SPACE bar to step to the appropriate interface connector
number (ENET 1 to ENET 4).
3. Press ENTER to display the ports on the chosen interface connector.
4. Use the arrow keys to highlight the Security State field for the
interface connector.
5. Use the SPACE bar to step to the appropriate security level
(NonSecure, LockOnNext, or LockedOnAddr).