Specifications

Port Level Security Configuration Screen
Local Management Supplement 2-5
7. To change the security on more than one connector, repeat step 1
through step 6 for each connector. Then proceed to step 8 to save all
settings at once.
8. Use the arrow keys to highlight the SAVE command.
9. Press ENTER. The message “SAVED OK” displays and all ports of
the connector are set to the selected operating mode.
2.3 PORT LEVEL SECURITY CONFIGURATION
SCREEN
The Port Level Security Configuration screen, Figure 2-3, functions
similarly to the Repeater Level Security Configuration screen, except that
it is used to set the security of each port of an interface connector.
To access the Port Level Security Configuration screen, use the arrow
keys to highlight the PORT LEVEL SECURITY CONFIGURATION
menu item on the Repeater Configuration Menu screen and press ENTER.
The Port Level Security Configuration screen displays.
Figure 2-3 Port Level Security Configuration Screen
NOTE
If LockedOnAddr is chosen as the Security State, the individual
port must be configured in the Port Level Security
Configuration screen. Refer to Section 2.3.
Port Security State Action On Intruder Address
1 [LockedOnAddr]
[DisablePort] [SendTrap] [xx-xx-xx-xx-xx-xx]
2 [NonSecure] [00-00-00-00-00-00]
3 [LockedOnAddr] [DisablePort] [SendTrap] [xx-xx-xx-xx-xx-xx]
4 [LockOnNext] [NoDisable] [SendTrap]
5 [LockOnNext] [DisablePort] [NoTrap]
6 [NonSecure] [00-00-00-00-00-00]
7 [NonSecure] [00-00-00-00-00-00]
8 [LockOnNext] [NoDisable] [SendTrap]
9 [LockOnNext] [DisablePort] [NoTrap]
10 [LockedOnAddr] [DisablePort] [SendTrap] [xx-xx-xx-xx-xx-xx]
11 [NonSecure] [00-00-00-00-00-00]
12 [LockedOnAddr] [DisablePort] [SendTrap] [12-34-1d-56-78-90]
SAVE INTERFACE #: [1] EXIT RETURN
27462_113e