Specifications

Chapter 1: Changes to Local Management Screens
1-30 Local Management Supplement
OPERATION MODE (Toggle)
Allows the user to set the specified port to transmit and receive data
separately (Standard) or simultaneously (Full Duplex). Set this field to
one of the following values:
• STANDARD ENET – The port is running in half duplex (default) and
either transmits data or receives data, but not both at the same time. To
set Ethernet ports for Standard operation, refer to Section 1.11.1.
• FULL DUPLEX – Depending on the SmartSwitch, the port transmits
and receives data simultaneously at 10 or 100 Mbps, thus enabling the
port to effectively switch at 20 or 200 Mbps. To set Ethernet ports for
Full Duplex operation, refer to Section 1.11.1.
LINK STATUS (Read-only)
Indicates whether there is a physical connection from this port to another
Ethernet module. One of the following values displays:
• Link – A link signal is present; there is a valid physical connection
from this port to another module.
• No Link – No link signal is present; there is no valid physical
connection from this port to another module.
PORT STATUS (Read-only)
Indicates whether the port was turned on or off administratively (by the
user). One of the following values is displayed:
• ENABLED – The port is turned on administratively.
• DISABLED – The port is turned off administratively.
SET ALL PORTS (Toggle)
All front panel ports can be set at once to either STANDARD or FULL
DUPLEX from this field. To set ports, refer to Section 1.11.1.
NOTE
Enabling or disabling ports from the Switch Configuration
screen is described in Section 1.20.3.