Specifications

Chapter 3: LM Security Screens for 6H123-50 and 6H133-37
3-2 Local Management Supplement
The following introduces each screen that is accessible from the Repeater
Configuration Menu.
REPEATER PORT CONFIGURATION
Used to monitor the link status and current operating mode of each port
on the 10-Mbps or 100-Mbps network of a front panel connector, and also
to turn each port on or off. For details, refer to Section 3.2.
MODULE LEVEL SECURITY CONFIGURATION
Used to set the security state for all ports on one connector
simultaneously. All ports on a connector can be set to receive all frames
(NonSecure state), lock on the source address of the next frame received
(LockOnNext), or lock on a specific address (LockedOnAddr). For
details, refer to Section 3.3.
PORT LEVEL SECURITY CONFIGURATION
Used to set security for each port of a connector. For details, refer to
Section 3.4.
3.2 REPEATER PORT CONFIGURATION SCREEN
The Repeater Port Configuration screen, Figure 3-2, is used to monitor
the link status and current operating mode of each repeater port on a
10-Mbps or 100-Mbps network of a front panel connector. The screen is
also used to change the operating mode, and turn each repeater port on
(enable) or off (disable).
To access the Repeater Port Configuration screen, use the arrow keys to
highlight the REPEATER PORT CONFIGURATION menu item from
the Repeater Configuration Menu screen and press ENTER. The Repeater
Port Configuration screen displays.