User`s guide

Port Level Security Configuration Screen
6E123-50 and 6E133-49 User’s Guide 5-93
7. If the security level chosen causes the DisablePort and SendTrap
fields to display under Action On Intruder, use the arrow keys to
highlight the DisablePort field.
If the security level chosen does not cause the fields to display under
Action On Intruder, proceed to step 11.
8. To change the DisablePort setting to NoDisable, press the SPACE
bar to toggle the setting.
9. Use the arrow keys to highlight the SendTrap field.
10. To change the setting to NoTrap, press the SPACE bar to toggle the
setting.
11. If the security state selected is LockedOnAddr, use the arrow keys to
highlight the Secure Address field for the port. Otherwise go to step
13.
12. Enter the address to lock on.
13. To change the security on more than one connector, repeat steps 1
through 11 for each connector. Then proceed to step 14 to save all
settings at once.
14. Use the arrow keys to highlight the SAVE command.
15. Press ENTER. The message “SAVED OK” displays and all ports of
the connector are set to the selected operating mode.