User`s guide

Chapter 5: Local Management
5-92 6E123-50 and 6E133-49 User’s Guide
Action On Intruder (Toggle)
Used to select the actions taken for the selected security state. There are
two fields to select the actions. Both toggle to activate or deactivate the
action.
• DisablePort/NoDisable – DisablePort causes the switch to turn off the
port that had a security violation. With NoDisable set, the port is not
turned off.
• SendTrap/NoTrap – SendTrap causes the switch to send an SNMP trap
when a port detects a security violation. With NoTrap set, no SNMP
trap is sent.
Secure Address (Modifiable)
Used to enter the source address for the LockedOnAddr security state
setting. Any other address seen is considered an intruder, and the module
will execute the actions selected in the Action on Intruder field. When the
security state setting is NonSecure, the field displays the source address of
the last frame.
INTERFACE # (Selectable)
This command field selects the front panel interface connector to which
the port security settings will be applied, (i.e., ENET 1 to ENET 4).
5.27.1 Setting the Port Level Security
To set the security for each repeater port on a connector, proceed as
follows:
1. Use the arrow keys to highlight the INTERFACE # field.
2. Use the SPACE bar to step to the appropriate interface connector
number, (ENET 1 to ENET 4).
3. Use the arrow keys to highlight the STATE field for the interface
connector.
4. Use the SPACE bar to step to the appropriate security level (Secure or
NonSecure).
5. Use the arrow keys to highlight the Lock/Learn field for the interface
connector.
6. Use the SPACE bar to step to the appropriate type of security
(LockOnNext or LockedOnAddr).