User`s guide

Repeater Level Security Configuration
6E123-50 and 6E133-49 User’s Guide 5-89
Action On Intruder (Toggle)
Used to select the actions taken for the selected security state. There are
two fields to select the actions. Both toggle to activate or deactivate the
action.
• DisablePort/NoDisable – DisablePort causes the switch to turn off the
port that had a security violation. With NoDisable set, the port is not
turned off.
• SendTrap/NoTrap – SendTrap causes the switch to send an SNMP trap
when a port detects a security violation. With NoTrap set, no SNMP
trap is sent.
5.26.1 Setting the Repeater Level Security
To set the repeater security for each connector, proceed as follows:
1. Use the arrow keys to highlight the STATE field for the interface
connector.
2. Use the SPACE bar to step to the appropriate security level (Secure or
NonSecure).
3. Use the arrow keys to highlight the Lock/Learn field for the
connector.
4. Use the SPACE bar to step to the appropriate type of security
(LockOnNext or LockedOnAddr).
5. If the security level chosen causes the DisablePort and SendTrap
fields to display under Action On Intruder, use the arrow keys to
highlight the DisablePort field. If the security level chosen does not
cause the fields to display under Action On Intruder, proceed to step 9.
6. To change the DisablePort setting to NoDisable, press the SPACE
bar to toggle the setting.
7. Use the arrow keys to highlight the SendTrap field.
8. To change the SendTrap setting to NoTrap, press the SPACE bar to
toggle the setting.
9. To change the security on more than one connector, repeat steps 1
through 8 for each connector. Then proceed to step 10 to save all
settings at once.