User`s guide

Chapter 4: Monitoring and Managing the 3F00-01 and 3F55-01
Page 4-2 FDDI Dual-Attached Intelligent Module User’s Guide
4.1 DISPLAYING THE MODULE STATUS
To display the status of the 3F00-01 and 3F55-01, at the LCM prompt
type:
ATX >status
Current Number of Learned Addresses: 34
Number of Defined Filters: 2
ModuleType DiagStatus InUse TempOk Ports
1 PPE Passed True Normal 1
2 FDDI–IOM Passed True Normal 2
3 CSMA–IOM Passed True Normal 3
4 HSSI–IOM Passed True Normal 4
5 IFDDI–IOM Passed True Normal 5
6 TR–IOM Passed True Normal 6
Displaying the 3F00-01 Port Status
To display the status of a 3F00-01 or 3F55-01 port using LCM, at the
LCM prompt type:
ATX > status <port number>
The port number is determined by counting from the first port on the
top-most module in the ATX, which is the Packet Processing Engine
(PPE).
The status of a 3F00-01 or 3F55-01 port includes:
• Type – There are six possible values for the module type, two for the
3F00-01 and four for the 3F55-01. The types are listed below:
- FDDI DAS
- FDDI DAS Single Mode
- Intelligent FDDI DAS
- Intelligent DAS Single Mode
- Intelligent DAS Single Mode on MIC A
- Intelligent DAS Single Mode on MIC B
• Bridging – which functions have been enabled for bridging (see the
bridge command).
• Routing – which functions have been enabled for bridging (see the
iproute or ipxroute commands).