Specifications

Application Views ATM Client Application
Device Management Page 30 SmartSwitch 2000
available when the appropriate High Speed
Interface Module (HSIM) is installed.
Table 15 lists the application-specific subviews
available from the Icon Subviews menu for the
ATM Client application:
ATM Client Application VCL View
This view provides a table containing detailed
information about the virtual channels passing
through this application. The ATM Client
Application Virtual Channel Link view provides
the following information.
Admin Status
This object is implemented only for a VCL that
terminates a VCC (i.e., one that is not cross-
connected to other VCLs). Its value specifies the
desired administrative state of the VCL. The Up
state indicates that the traffic flow for this VCL is
enabled. The Down state indicates that the traffic
flow for this VCL is disabled.
Oper Status
This object shows the current operational status
of the VCL. The Up and Down states indicate that
the VCL is currently operational or not
operational, respectively. The Unknown state
indicates that the status of this VCL cannot be
determined.
Last Change
This is the value of the MIB II’s sysUpTime object
at the time the VCL entered its current
operational state. If the current state was entered
prior to the last re-initialization of the agent, then
this object contains a zero value.
RTD (Receive Traffic Description) Index
The value of this object identifies the row in the
ATM Traffic Descriptor Table that applies to the
receive direction of this VCL.
Table 15: ATM Client Application Subviews
menu
Menu Selection Description
Configuration Opens the Device
Configuration view described
in Configuration Views.
VCL Table Opens the ATM Client
Application VCL View
(Page 30).
Interfaces Opens the Interfaces view
described later in this
section.