User`s guide

Chapter 2: Installation
2-6 VHSIM-G6 User’s Guide
7. Align the VHSIM-G6 connectors with the pins on the standalone
device.
8. Press down firmly on the VHSIM-G6 until the connectors slide all the
way onto the pins. Ensure that the standoffs on the standalone device
align with the standoff screw holes on the VHSIM-G6.
9. Secure the VHSIM-G6 to the module faceplate using the mounting
screws saved in step 5.
10. Secure the VHSIM-G6 to the module standoffs using the standoff
screws shipped with the VHSIM-G6.
11. Reattach the chassis cover to the standalone device, reconnect the
power cord, and reconnect the standalone device to the network.
2.3 INSTALLING GPIMs
The VHSIM-G6 has two different GPIMs that can be installed into the
VHSIM-G6. Both GPIMs are installed into the VHSIM-G6 in the same
manner, as listed in this procedure.
After installing a GPIM-01 or GPIM-09, refer to Section 2.4 for details on
connecting the GPIM to the network.
Refer to Appendix B for cable specifications for the GPIMs.
!
CAUTION
When inserting the VHSIM-G6 onto the device pins, ensure
that the pins do not bend, as this can damage both the device
and the VHSIM-G6.
Ensure that the chassis cover is in place before reconnecting
the power cord.
NOTE
The GPIMs are hot swappable, therefore they can be installed
into the VHSIM-G6 at any time during the installation of the
VHSIM-G6.