User`s guide

9033194 SmartSTACK ELS100-24 Firmware Revision 2.01 5
A.3.1 Configuring SmartTrunking: User Interface
SmartTrunking can be configured through the user interface.
A.3.1.1 SmartTrunking Configuration Menu
To configure Trunking, do the following:
1.
Select Switch Configuration Menu from the Main Menu.
2.
Select Trunking Configuration Menu. Figure A-3 shows the Trunking
Configuration menu.
Figure A-3. Trunking Configuration Menu
Ports that are members of a trunk group are indicated as
such by an asterisk ’ * ’ next to the port number on the Port
Menu of the user interface.
TRUNKING CONFIGURATION Access Control: READ/WRITE
Trunking Enabled Yes
Trunking Protocol Yes
ID NAME PORTS IN TRUNK
---------------------------------------------------------------------------------------------
d. Protocol Enable e. Enable x. Previous Menu
Enter Selection: