User`s guide

14 SmartSTACK ELS100-24 Firmware Revision 2.01 9033194
A.5 Read-only Password Protection
Read-only password protection has been added in firmware revision 2.01.
This feature adds an additional password option to the user interface (for
serial console and Telnet) for read-only access. Previously only read/
write password protection was available. To configure read-only
password protection, do the following:
1.
Select System Configuration Menu from the Main Menu (Figure
A-13).
Figure A-13. System Configuration Menu
2.
Select READ ONLY Password. The following message appears:
Enter New Password:
3.
Enter a password containing six to eight alphanumeric characters
and press [Enter]. The following message appears:
Re-enter New Password:
4.
Enter the password again and press [Enter] to confirm. If the
password is re-entered correctly, the following message appears:
Password Changed
Press any Key to Continue
Refer to the Installation and User Guide, Chapter 3, “
Setting
Password Protection
” for more information.
SYSTEM CONFIGURATION Access Control: READ/WRITE
a. SNMP Configuration Menu
b. System Name
c. System Location
d. System Contact
e. IP Address 000.000.000.000
f. Subnet Mask 000.000.000.000
g. Default Gateway 000.000.000.000
h. BootP/DHCP Enable Yes
i. Screen Timeout (minutes) 0
j. READ/WRITE Password
k. READ ONLY Password
l. Terminal Baud Rate 9600
m. Power Up Diagnostics Yes
n. Syslog Server IP Address 000.000.000.000
o. Lowest Syslog Severity Level warning
p. Web Management Enable Yes
x. Previous Menu
Enter Selection: