User`s guide

9033194 SmartSTACK ELS100-24 Firmware Revision 2.01 7
Table A-2 describes the Trunk Configuration menu.
Table A-2. Trunking Configuration Menu Description
5.
Select
a
to add ports. The following message appears:
Enter Port Number(s) or Range of Port(s) 1-26:
Field Description
Name Lists the trunk group name. Use the Trunk Name op-
tion to create a trunk group name (1-14 characters).
Trunk Status Lists the trunk group status: PARTIAL (one or more of
the trunk group ports are linked and one or more are
not linked), CONNECTED (all ports in the trunk group
are linked), DISCONNECTED (no ports in the trunk are
linked).
Trunking Protocol Indicates whether trunking protocols are enabled (Yes)
or disabled (No).
Port Identifies the port by number.
Enabled Indicates whether the port is enabled (Yes) or disabled
(No).
Link Status Indicates port link status: connected or disconnected.
Selection Description
Add Port(s) Allows you to add port(s) to the trunk.
Remove Port(s) Allows you to remove port(s) from the trunk.
Trunk Name Allows you to create a unique trunk group name (1-14
characters).
Protocol Enable Allows you to enable (Yes) or disable (No) the opera-
tion of the trunking protocols on this trunk.