Specifications

9030751 E7 Event and Alarm Messages
4-7
MRXI-22/24 Events and Alarms
CsEvFormat/Event000d0126
{d "%w- %d %m-, %Y - %T"} System
Voltage Normal condition has been
detected by {m} ({t}). (event [{e}])
CsPCause/Prob000d0126
The problem with the internal 5 volt line
of the system has been corrected.
CsEvFormat/Event000d0127
{d "%w- %d %m-, %Y - %T"} An EPIM has
been removed from port {I 3} on module in
slot {I 1} of {m} ({t}). (event [{e}])
CsPCause/Prob000d0127
An Ethernet Port Interface Module
(EPIM) has been physically removed.
CsEvFormat/Event000d0128
{d "%w- %d %m-, %Y - %T"} An (EPIM)
has been inserted into port {I 3} on module
in slot {I 1} of {m} ({t}). (event [{e}])
CsPCause/Prob000d0128
An Ethernet Port Interface Module
(EPIM) has been physically inserted.
CsEvFormat/Event000d0129
{d "%w- %d %m-, %Y - %T"} Traffic
threshold, {I 1} packets per {I 3} seconds,
exceeded on the repeater network {I 5} of
{m} ({t}). (event [{e}])
CsPCause/Prob000d0129
The device(s) attached to this channel
may have an application level problem.
The attached devices may be operating
properly, but the application requires a
large amount of network bandwidth.
CsEvFormat/Event000d0130
{d "%w- %d %m-, %Y - %T"} Error
threshold exceeded. An error threshold, of
{I 1}% total packets in {I 5} seconds,
exceeded on repeater network {I 7} of {m}
({t}). (event [{e}])
CsPCause/Prob000d0130
1) A malfunctioning device is present on
this channel. 2) A cable fault exists.
CsEvFormat/Event000d0131
{d "%w- %d %m-, %Y - %T"} Collision
threshold exceeded. The number of
collisins per total packets within the time
base of {I 3} seconds has been exceeded on
repeater network {I 5} of {m} ({t}). (event
[{e}])
CsPCause/Prob000d0131
1) A malfunctioning device is present on
this channel. 2) A cable fault exists. 3)
Collisions are usually caused by many
nodes contending for the network. As
traffic rates increase, the collision rate
usually follows. Therefore, if this channel
has a high bandwidth utilization, a high
collision rate is not unlikely.
CsEvFormat/Event000d0132
{d "%w- %d %m-, %Y - %T"} Network port
security is {T LockStatus 1} on repeater
network {I 3} of {m} ({t}). (event [{e}])
CsPCause/Prob000d0132
The network administrator has changed
the status of port locking for this repeater
channel. The security feature locks all
ports on this repeater channel so that only
a valid user already in the source address
table can access the network.
Table 4-1. MRXI-22/24 Events and Alarms (Continued)