Specifications

Repeater Configuration View
Trap Configuration
Configuration Views MRXI-22/24
3-6 Management Module Guide
Trap Configuration
This area of the Repeater Configuration view allows you to enable or disable
any of the following types of traps:
Allows you to Enable the Link Trap generation, such that all packets
indicating a change in link status are reported within the trap database.
Allows you to Enable the Segmentation Trap generation, such that all packets
indicating a change in segmentation status are reported within the trap
database.
Allows you to Enable the Source Address Trap generation, such that all
packets indicating a change in source address are reported within the trap
database.
Alarm Configuration
This area of the Repeater Configuration view provides the following
configuration and status information for generating alarms for the device:
Timebase
Allows you to set the number of seconds used as the interval for performing all
of the rate alarm checks. The minimum is 10 seconds. For example, if the
timebase is 10 seconds, an alarm will occur only when the specified number of
errors occur within 10 seconds.
Allows you to configure whether traffic alarms are disabled or enabled.
Traffic Threshold
Displays the threshold number of packets, within the alarm timebase, that
will generate a traffic alarm. You can modify this value.
Allows you to configure whether collision alarms are disabled or enabled.
Link Traps
Segmentation Traps
Source Address Traps
Traffic Alarms
Collision Alarms