User guide

ISDN Router

• TCP/IP route addressing and routing protocol controls

• If configuring IPX: IPX Routes addressing and IPX SAPs services

5. Bridging / Routing

• Set the default bridging destination

• Enable IP routing

• If configuring IPX: Enable IPX routing

• Enable the Internet Firewall

• Enable WAN-to-WAN Forwarding

6. Store

Save the router’s configuration

7. Reboot the router

8. Verify the router’s configuration

As you step through the configuration, each setting you change results in a

dynamic update of the router’s configuration. Some changes, though, don’t

take effect until you store the configuration and reboot the router.

Note: Changes requiring a reboot of the router

System Settings:

Ethernet IP

IPX Address and options

Bridging and Routing Controls:

TCP/IP Routing

IPX Routing

Default Bridge Destination

Remote Router:

TCP/IP Route Addresses

IPX Routes

IPX SAPs

Bridging

Add or remove remote router entries