User guide

ISDN Router
120
Connecting the router to the PC
You will use the following.cable and.adapter:
• One 10-foot length of unshielded twisted pair cable with RJ45 connectors
on either end. This cable has a green label marked “Console”.
• One RJ45 to DB9 adapter (console port to PC)
Instructions
1. Plug the RJ45 connector at one end of the cable into the RJ45 jack
marked console on the back panel of the router.
2. If you are connecting directly to a workstation, attach the DB9 adapter to
the other end of the cable and connect that end to your workstation.
Note: Pinouts for the RJ45 connector are provided in the Quick Start Guide.
Accessing the Command Line Interface
The Command Line Interface is available at all times once you have installed
the router’s hardware, connected the PC with a terminal emulation session (or
ASCII) session, and powered the unit on. For specifics regarding the CLI
commands, refer to Command Line Interface guide (provided on diskette 3).