Specifications

Modeling Preparation for Modeling
Device Management Page 59 SmartSwitch 6000/Matrix E6
Preparation for Modeling
Before modeling the chassis, you should be
familiar with the process of creating models and
accessing views. Refer to Getting Started with
SPECTRUM for Administrators and How to
Manage Your Network with SPECTRUM for
instructions. You should also be familiar with any
network management and firmware requirements
described in the 6C105/6C107 chassis firmware
documentation.
Modeling Using the Chassis IP
The chassis model can only be placed in a Room
Location view. The Room Location view is created
by starting at the Universe level view and
navigating into the Room Location level, as
described below.
1 At the Universe level, select View > New View
> Location.
This places you at the top level of the Location
views.
2 Access the Edit mode and select Edit > New
Model.
The Select Model Type dialog box displays
(Figure 18).
Caution:
Caution:
For proper modeling, the chassis and its
installed modules must not be in Mixed
Management mode. Each module should
have its own IP address or the chassis
should be configured with a single IP
address.