Specifications

Configuration Views Repeater Configuration View
Device Management Page 51 SmartSwitch 6000/Matrix E6
number of active VPI bits configured for use
ranges from 0 to 8.
Max VCI (Virtual Channel Identifier) Bits
The maximum number of active VCI bits
configured for use at this ATM interface.
ILMI (Interim Local Management Interface) VPI
The VPI value of the VCC supporting the ILMI at
this ATM interface. If the values of both ILMI VPI
and ILMI VCI equal 0, then the ILMI is not
supported for this ATM interface.
ILMI VCI
The VCI value of the VCC supporting the ILMI at
this ATM interface. If the values of both ILMI VPI
and ILMI VCI equal 0, then the ILMI is not
supported for this ATM interface.
Address Type
The type of primary ATM address configured for
use at this ATM interface.
Admin Address
The address assigned for administrative
purposes. If this interface has no assigned
administrative address or if the address used for
administrative purposes is the same as that used
for the physical address, then this is an octet
string of zero length.
Neighbor Address
The IP address of the neighbor system connected
to the far end of this interface to which a Network
Management Station can send SNMP messages as
IP datagrams to UDP port 161 in order to access
network management information concerning the
operation of that system.
Neighbor If Name
The name of the interface on the neighbor system
at the far end of this interface, and to which this
interface connects. If the neighbor system is
manageable through SNMP and supports the field
ifName, the value of this field must be identical to
that of the ifName for the ifEntry of the lowest
level physical interface for this port. If this
interface does not have a name, the value of this
field is a zero length string.
Repeater Configuration View
Access: From the Chassis Device view highlight the
appropriate Repeater label on the Chassis Module icon,
from Icon Subviews menu, then select Repeater
Configuration.
The Repeater Configuration view provides
information on the configuration and operating
status of the selected repeater interface. This view
is divided into the four areas described below: