Specifications

Introduction The SPECTRUM Model
Device Management Page 12 SmartSwitch 6000/Matrix E6
The SPECTRUM Model
SPECTRUM uses a single model type for modeling
and managing individual basic SmartSwitch
modules or groups of modules on a network
installed in, or connected to, the chassis.
SPECTRUM also uses a single model type for
modeling and managing the HSIM modules. The
models provide access to the information needed
to manage the modules, including software
emulation of the actual module attributes and
functionality. Refer to Modeling on Page 55 for
modeling instructions.
The model type designators for the SmartSwitch
6000 use an under bar to replace the dash in the
device model number. For example, 6E122_26
refers to the model type for the 6E122-26 module.
SPECTRUM’s AutoDiscovery (as well as manual
modeling procedures) results in the creation of
Device icons that represent the modules. These
icons provide double-click zones and Icon
Subviews menus that let you access views
displaying performance and configuration
information.
Figure 2 shows examples of the device icons.
Figure 2: Small and Large Device Icons
The device-specific Icon Subviews menu options
available from the Device icon are listed below.
Option Accesses the...
Fault
Management
Fault Management View, which is
described in the How to Manage Your
Network with SPECTRUM
documentation.
Device Device Views (Page 16)
10
1
.1
.01
IP Address
6H203_24
IP Address
6H203_24
Small Device icon appears in
Topology and Application views
Large Device icon appears in
Device Topology, Location, and
Device Interface views.