User manual

ManualsBrandsCables Unlimited ManualsComputer equipmentSPK-SHOWER2

SPK-ROCK2

Add-On

900MHz Digital Wireless

Rock Speaker

Single Add-On Unit

to be used in conjunction with your previously purchased

SPK-ROCK 900MHz Wireless Rock Speaker Set

User Manual

www.audio-unlimited.com

www.cablesunlimited.com

P.1

INTRODUCTION

This add-on unit is to be used with your current 900 MHz wireless Rock speaker

system (SPK-ROCK).900 MHz digital hybrid wireless rock speaker system uses the

latest wireless technology to enable you to enjoy music and TV sound anywhere

inside or outside your home. You simply connect the system to any audio source

such as Radio, TV, VCR, Hi-Fi and CD/MP3/VCD/DVD/Blu-ray player. Without any

complicated wiring and installation this system enables you to enjoy incredible, bona

fide sound in minutes.

FEATURES

1. Weatherproof outdoor rock speaker.

2. Automatic Phase Lock Loop (PLL) scanning system on speaker receiver.

3. Phase Lock Loop (PLL) transmission system on transmitter.

4. 900 MHz RF technology rock-type outdoor speaker system.

5. RF technology lets you place the rock speaker freely anywhere in your

home/garden.

6. Operating distance up to 150 feet.

7. No line of sight limitation.

8. Virtually interference free audio quality.

9. Auto ON/OFF.

10. Auto tuning function.

11. Auto shut-off on speaker.

12. Volume up/down control.

13. Power on/off.

14. 2-way speaker.

Summary of content (5 pages)

PAGE 1
INTRODUCTION This add-on unit is to be used with your current 900 MHz wireless Rock speaker SPK-ROCK2 system (SPK-ROCK).900 MHz digital hybrid wireless rock speaker system uses the latest wireless technology to enable you to enjoy music and TV sound anywhere inside or outside your home. You simply connect the system to any audio source Add-On such as Radio, TV, VCR, Hi-Fi and CD/MP3/VCD/DVD/Blu-ray player.
PAGE 2
COMPONENT IDENTIFICATION INSTALLATION INSTRUCTIONS TRANSMITTER (Not included with SPK-ROCK2) TRANSMITTER (Not applicable with SPK-ROCK2 -already set up with your Antenna SPK-ROCK system). USE THE SAME GUIDELINES TO CONNECT YOUR ADD-ON WIRELESS SPEAKER (SPK-ROCK2) 1. Insert the antenna tube into the antenna wire. 2. Connect the supplied AC/DC power adapter to an electrical wall outlet. 3. Plug the AC/DC power adapter in the DC jack located on the rear of the transmitter. 4.
PAGE 3
SPEAKER RECEIVER 1. 4. Volume can be adjusted up by pressing the “+” button, or down by pressing the button “-“ to the desired listening level. Plug in the power adapter with the rock speaker and AC power outlet to charge the lead acid battery built inside the rock speaker. The battery pack must be charged at least 15 hours before the first operation. 2. The rock speaker can be operated either with power supplied by battery pack or from AC outlet with connection of power adapter.
PAGE 4
6. Switching Off a) To protect the transmitter and save power, the transmitter will turn off TROUBLE SHOOTING automatically if it detects that the unit is not being operated or, there is NO SOUND weak reception from the signal audio source, for 4 minutes. - In other words, if the signal comes back, the transmitter will work again automatically. b) power connection input on the transmitter. - Ensure the speaker is switch ON.
PAGE 5
NOTE: TECHNICAL SPECIFICATIONS This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to Transmission Mode : UHF provide reasonable protection against harmful interference in a residential installation.