User guide

39
C5) This will correct the cable route lengths that may be incorrect based upon the changes in raceway length.
This is automatic when an issue is made
C6) This function will refresh the EST_LEN field for each cable where the EST_LEN was not input by a user and
the From/To (or ASSOC Equip) locations are available. Lengths are calculated as 1.3 times the Delta XYZ length
between cable ends plus the Additional Len in Project Data.
C7) Deletes AutoDoIT unused conduits and dropouts
Tools provide functions that automate the preparation of data.
T1) Transfers equipment tags from cable from/to that are not in the equipment table.
T2) Sets start-up system for cables (which are blank) to the system of it’s connecting equipment. Please read the
rules procedure indicated below.
T3) This function is used only in PANEL model types. It calculates pull code.
T4) This function lists cables that are common pulls for the raceways that you input in the list.
Warning - cables listed in your output may be entering or exiting the tray at any point of the tray run. If
this is an issue, please use TrayMatic Cool Tools to show all the cables at the start the pull and then
selecting the cables at the end of the pull.
T5) Please refer to the CM+ BuilderGuide.pdf, paragraph 5.6.