Instruction manual

FIGURE 3
Tray
Head
7. Insert the neck of the Tray into the Feed
Chute (Figure 3).
8. Loosen the Allen Screws in the Tray
Guard until the screw ends are flush with the
Tray Guard (Figure 4).
9. Align the curved ends of the Tray Guard
with the curved sides of the Tray. The hole on
the Tray Guard will line up with the hole in the
Tray.
10. The tabs of the Tray Guard will fit over the
sides of the Tray. Gently press down on the
Tray Guard until it fully seats onto the sides of
the Tray, curving into the Tray (Figure 5).
11. Tighten the Allen Screws with the Allen
Wrench to secure the Tray Guard onto the
Tray. DO NOT OVERTIGHTEN the Allen
Screws.
12. NEVER operate Grinder without the Tray
and the Tray Guard secured in place.
REFER TO “GRINDING INSTRUCTIONS”
FIGURE 4
Tray
Allen Screws
Tray Guard
FIGURE 5
Tray Guard
NEVER operate Grinder without the Tray and
the Tray Guard secured in place.
To avoid serious or fatal injury, NEVER reach
into any Grinder inlet.
ALWAYS use the Stomper to push meat
into the Grinder Head.
Read & fully understand all instructions
& warnings prior to use.
WARNING!
7. Insert the neck of the Tray into the Feed
Chute (Figure 14).
8. Loosen the Allen Screws in the Tray
Guard until the screw ends are flush with the
Tray Guard (Figure 4).
9. Align the curved ends of the Tray Guard
with the curved sides of the Tray. The hole on
the Tray Guard will line up with the hole in the
Tray.
10. The tabs of the Tray Guard will fit over the
sides of the Tray. Gently press down on the
Tray Guard until it fully seats onto the sides of
the Tray, curving into the Tray (Figure 5).
11. Tighten the Allen Screws with the Allen
Wrench to secure the Tray Guard onto the
Tray. DO NOT OVERTIGHTEN the Allen
Screws.
12. NEVER operate Grinder without the Tray
and the Tray Guard secured in place.
REFER TO “STUFFING INSTRUCTIONS”
FIGURE 14
Tray
Head
FIGURE 15
Tray
Allen Screws
Tray Guard
FIGURE 16
Tray Guard
NEVER operate Grinder without the Tray and
the Tray Guard secured in place.
To avoid serious or fatal injury, NEVER reach
into any Grinder inlet.
ALWAYS use the Stomper to push meat
into the Grinder Head.
Read & fully understand all instructions
& warnings prior to use.
WARNING!
-10-
-15-
Feed
Chute
Neck
Feed Chute
Neck
Allen Wrench
Allen Wrench