Operator`s manual

cab Produkttechnik GmbH & Co KG

PRODUCT MARKING AND BARCODE IDENTIFICATION

Chapter 3 Maintenance

Warning:

1. Make sure the printer is powered OFF before performing any maintenance operation.

2. The printhead becomes hot while printing, be careful, when maintaining the printhead.

3. Use only the cleaning agents indicated. cab Produkttechnik Gmbh & Co KG will not be

responsible for damage caused by any other cleaning materials used on this printer.

4. Anhydrous isopropyl alcohol is a solvent of isopropyl alcohol containing no more than

one percent water. Isopropyl alcohol is a flammable solvent; always take the proper

precautions when using this solvent.

Cleaning the Printhead

The printhead is easily damaged due to its precision configuration. A

printhead damaged by misuse is not covered under the terms of the

warranty. To promote longevity of the printhead, please note the

following:

1. Always use proper cleaning materials and techniques to clean the

printhead. Never use hard materials to scrape the printhead.

2. Always use high-quality consumables. When the TPH module is

closed, pressure is placed on the TPH directly; dirt such as paper

scraps, sand, dust and water can scrape or damage the printhead.

The TPH is also easily damaged by static electricity, which may

be generated by low-quality ribbons.

3. After every roll of ribbon or every three rolls of media, the

printhead should be cleaned with anhydrous isopropyl alcohol.

a. Power off the printer and open the cover.

b. Release and lift the Printhead Module.

c. Remove the ribbon (if applicable).

d. Using a Cotton Swab dipped in anhydrous isopropyl alcohol,

rub the Cotton Swab along the printhead.

Cleaning the Platen Roller

Debris or dirt on the platen roller should be cleaned after every three

rolls of media.

a. Power off the printer and open the cover.

b. Release and lift the Printhead Module.

c. Rotate the platen roller and clean it thoroughly with anhydrous

isopropyl alcohol and a cotton swab.

Cleaning other Parts of the Printer

Media Sensor: blow with air monthly, if more thorough cleaning is

required, gently wipe the sensor with anhydrous

isopropyl alcohol and a cotton swab.

Peel/Tear Bar: gently wipe with anhydrous isopropyl alcohol and a

cotton swab (Peeler kit and Cutter kit only).