Operator`s manual

cab Produkttechnik GmbH & Co KG

PRODUCT MARKING AND BARCODE IDENTIFICATION

Buttons

Three buttons perform different functions based on the mode the printer is in. The printer operates in one

of the following modes:

Normal Mode: Normal printer functions (i.e. Pause, Feed, and Cancel). See the table below.

System Mode: Allows the printer to perform Reset, Media Sensor Calibration and Self-testing.

See the following table at section ‘System Mode’.

Setting Mode: Only for G-2108D and G-3106D. Allows setting of the printer’s operating menu items

(i.e. Media Settings, Communications, and Options). See section ‘Setting from

LCD Panel.

Mode Normal Mode System Mode

FEED Feeds one label Media Sensor Calibration

PAUSE -Press once to pause Self-test:

current print job the printer performs a

-Press a second time to self-test and prints out a

resume work c onfiguration report

CANCEL -Cancels current batch Reset:

of labels reset the printer to

-Forces the printer to Factory Default Settings

continue working

after an error has

been solved

System Mode

In System Mode the printer’s buttons allow the printer to perform Reset, Media Sensor Calibration and

Self-testing. The printer cannot receive commands from the host when in System Mode.

- Entering: Press and hold CANCEL button for 4 seconds, the three blinking lamps indicate the printer

is in System Mode.

- Exiting: The printer will exit System Mode automatically if no further operations are requested in 4

seconds after entering System Mode.

Reset – Reset the Printer to Factory Default Settings

Following the steps listed below allows you to reset the printer to factory default settings.

1. After entering System Mode, press CANCEL button.

2. The three indicators stop blinking and remain lit. The printer is back to a normal state.