Technical data

22
9.8
8
4 3 2 1
5 6 7
9.9
9 .1 0
Applicator A3200
Real-time application
With the A3200 applicator labels that are printed with the A2
+
or A4
+
printers are automatically applied on a product. A rotary cylinder allows
positioning the label between 45° and 95°. Finally, the label is placed on
the product via short stroke cylinder.
Applicator A3200
Usage A2
+
, A4
+
Rotary cylinder 45°-95°
Lifting cylinder up to mm 30
Compressed air bar 4.5
1
2
3
4
5
6
7
8
Long service life
The ball-bearing guides are low-wearing.
Variable angular position
The rotary cylinder allows labeling on horizontal, inclined and vertical
surfaces.
Pre-dispensing button
For testing the labelling process. Pushing the button the first time
causes the label to be printed and held by the pad. Pushing the
button again starts the application.
Compressed air regulation unit
Microfilters prevent contamination. The compressed air regulator
ensures a permanent high labeling quality.
High process reliability
The supporting air jet stream, induction air and lifting speed can be
adjusted. The pressure can be reduced to less than 10 N (1 kg) for
highly sensitive products and packaging. To avoid contamination of
the vacuum holes, these are cleaned with air pressure after each
application.
Label sizes
Labels with 4 to 116 mm width and 5 to 80 mm height can
be applied.
Supporting air
Used for blowing the label onto the pad
Digital I/O interface
A PLC, sensor or hand switch starts the labeling. At the same time,
status and error messages are issued.
Inputs:
Start
Print first label
External error
Stop (external error)
External reset only for 25-pin
Outputs:
Printer not ready
No print job
Collective alarm
Home position reached
Labeling position reached
Labeling error
Tamp pads or blow pads are manufactured according to the label size.
Tamp pad A3221 Blow pad A3221
Usage A2
+
A4
+
A2
+
A4
+
Label width mm 4-63 20 -116 10-63 20 -16
Label height mm 5-80 10-80
Product surface Flat
Product during labeling Not moving In motion