Technical data

20
1
2
3
4
5
6
8
7
9.3
Applicator A1000
Real-time application
Combined with the A2
+
, A4
+
and A6
+
printers the A1000 applicator
means a cost-effective solution - for both semi-automatic operation and
integration into product lines. For operation compressed air of 4,5 bar is
needed.
1
Long service life
The ball-bearing guide bars are low-wearing.
2
Variable product heights
The lifting cylinder allows labeling at different heights. Different stroke
heights are available.
3
Pre-dispensing button
For testing the labeling process. Pushing the button the first time
causes the label to be printed and held by the pad. Pushing the
button again starts the application.
4
Compressed air regulation unit
Microfilters prevent contamination. The compressed air regulator
ensures a permanent high labeling quality.
5
High process reliability
The supporting air jet stream, induction air and lifting speed can be
adjusted. The pressure can be reduced to less than 10 N (1 kg) for
highly sensitive products and packages. To avoid contamination of
the vacuum holes, these are cleaned with air pressure after each
application.
6
Label sizes
Labels with 25 to 176 mm width and 25 to 200 mm height can
be applied.
Supporting air
Used for blowing the label onto the pad
Digital I/O interface
A PLC, sensor or hand switch starts the labeling. At the same time,
status and error messages are issued.
Applicator A1000-220 A1000-300 A1000-400
Usage A2
+
, A4
+
, A6
+
A2
+
, A4
+
, A6
+
A2
+
, A4
+
, A6
+
Cylinder stroke mm 220 300 400
Tamp stroke
below device mm
70 150 250
Compressed air bar 4.5
Inputs:
Start
Print first label
External error
Stop (external error)
External reset only for 25-pin
Outputs:
Printer not ready
No print job
Collective alarm
Home position reached
Labeling position reached
Labeling error
7
8