Technical data

15
Extra equipment
Metal cover
On request, label printers A4
+
and A6
+
are available with metal cover (standard with the A8
+
).
Print roller DR4-M25
For small and thin materials up to 25 mm width
Print roller DR4-M50
For very thin materials from 20 to 50 mm width
Print roller DR4-M80
For very thin materials up to 80 mm width
Reflective label sensor
From top
Adapter 100 mm diameter
To keep bending to a minimum during stacking it is recommended to use a
large core diameter.
Memory card
CompactFlash Type I
Standard keyboard
Connection USB, number of keys 115
External operation panel
If the operation panel is not accessible, after printer installation within a facility,
an external one can be connected. Additional slots are available for CompactFlash
memory card Type I and host interface.
Pause adapter PS7
For printing in a label loop. Print job is stopped by the pause signal, with
the label being printed finished first.
I/O interface Inputs: Outputs: No print job,
Pause, external error printer not ready, print job active
Tester CC for linear and 2D barcodes
A camera testing horizontally and vertically printed barcodes directly after printing. If the
code is faulty the print job is stopped and the label removed. The tester CC can be used
with tear-off mode, dispensing mode or external rewinder. For further details please refer
to the operation manual.
Interfaces
Centronics Interface
Bi-directional according to IEEE 1284
RS422/RS485
1,200 to 230,400 baud/8 bit
Label selection – I/O box
From a higher-level control, like a PLC, up to 16 different labels can be selected from the
memory card. The I/O box via abc programming enables to realize easy PLC programming
with four in- and outputs each.
WLAN 802.11b/g
Connecting cables
Connecting cable RS232 C, 9/9-pin, length 3 m
Patch cable CAT 5e, length 3 m, gray
Accessories - special equipment, interfaces, connecting cables
2.1
2.2
2.3
2.4
2.5
2.6
2.7
2.8
2.9
3.1
3.2
3.3
3.4
4.1
4.2